13
English
awill be displayed.
Playable Video Cassette Tapes
Philips Consume Electronics recommends that
only video cassette tapes that have the VHS
mark and High Quality (HQ) system is
compatible with this DVD/VCR.This
DVD/VCR has an Automatic Head Cleaner.
Recording Prevention
Video cassette tapes have record tabs to
ensure recordings are not erased accidentally.
1To prevent recording,break off the tab with a
screw-driver.
2To allow recording,cover the hole with
cellophane tape.
Notes:
– Use only tapes with VHS mark.
– Remove any adhesive stick-on notes from
the tape before inserting into the
DVD/VCR.
– Periodic maintenance is required to
maintain your DVD/VCR performance.
– Video heads will require replacement
after a period of time.Only an authorised
service center should perform this service.
1
2
LANGUAGE
ENGLISH
FRANÇAIS
ESPANOL
DEUTSCH
ITALIANO
SVENSKA
NEDERLANDS
[ ]
Turning on your DVD/VCR
The following steps should only be performed
if a power failure occurs or the DVD/VCR is
unplugged for more than 30 minutes.
1Turn on the TV and select the video channel
on the TV.
2Press the VCR button and then the STAND-
BY-ON button.
3Press the PLAY Bor STOP Cbutton repeat-
edly to select your desired language.
4Press the MENU button.
Video Channel Setting
Video channel setting will be necessary,if
your DVD/VCR is connected to the TV via
the coaxial cable.
1Insert a pre-recorded tape into the
DVD/VCR.The DVD/VCR will turn on and
start playback automatically.
If playback does not start,press the PLAY B
button.
2Select and adjust your TV to channel 36.
●If the playback picture appears on the TV
screen,continue with step 8.
●If channel 36 is employed for broadcasting,or
interference lines appear on the picture,the
RF converter must be set to a different chan-
nel between CH22 and CH69.Continue with
step 3.
3Press the MENU button.
4Press the PLAY Bor STOP Cbutton to
select INITIAL.Then,press the FF gbut-
ton.
5Press the PLAY Bor STOP Cbutton to
select RF OUT.Then,press the FF gbut-
ton.
6Press the PLAY Bor STOP Cbutton to
select a channel which is not used for broad-
casted between channel 22 and channel 69 in
your area,then press the FF g button.
awill be displayed.
RF OUT CH 36
Setting Up your DVD/VCR
7Press the MENU button to exit.
Set the TV channel to the RF OUT CHAN-
NEL which was selected on the DVD/VCR.A
picture from the VCR will appear on the TV
screen.If a picture does not appear,repeat
steps 3to 7using a different channel which is
not used for broadcasted.
8Press the STOP Cbutton to stop the tape.
Note:
– You may also access the RF OUT CH
menu by pressing and holding MENU for 3
seconds during power off until the RF
OUT CH menu appears.