CHANNEL SETTING

If you have changed antenna connection, we recommend that you program available channels in your area with the following procedures.

Auto Channel Scan

1 Press [SETUP] and use [K / L] to select “General Setting”, then press [OK].

“General Setting” menu will appear.

2 Use [K / L] to select “Channel”, then press [OK].

“Channel” menu will appear.

3 Use [K / L] to select “Auto Channel

Preset”, then press [OK].

4 Use [K / L] to select the type of broadcasting signal, then press [OK].

Auto Channel Preset

Antenna

Cable (Analog)

Cable (Analog / Digital)

The unit will start getting channels available in your area.

• When aerial antenna is connected, select “Antenna”.

• When connected to CATV, select “Cable (Analog)” or “Cable (Analog/Digital)”.

To cancel the auto channel preset during scanning:

Press [BACK ] or [SETUP] to cancel.

5 When scanning is over, press [SETUP] to exit.

To cycle through only the memorized channels, use [CH / ].

To select a channel directly (including the ones not memorized), use [the Number buttons].

Note

If the auto channel preset is canceled during presetting, some channels not yet preset may not be received.

You cannot change the channel when either VCR or DVD is in any recording mode (basic recording, one- touch timer recording or timer recording).

Introduction Connections Basic Setup Recording Playback

Editing Function Setup VCR Functions Others

EN 27

Page 27
Image 27
Philips DVDR3545V manual Channel Setting, Auto Channel Scan, Use K / L to select Channel, then press OK