Troubleshooting (cont’d)
E n g l i s h
Problem
The message 'Disc contains unknown data' appears.
The index screen flickers when a DVD+R is inserted.
Picture is fuzzy and brightness varies when copying DVD Video discs or prerecorded video cassettes.
The message ‘NO SIGNAL’ appears.
Solution
–This message may appear if you insert a disc that was not finalised. DVD+R's that have not been finalised are very sensitive to fingerprints, dust, or dirt.This may cause problems during recording. To use the disc again, do the following :
1)Make sure that the surface of the disc is clean.
2)Press OPEN/CLOSE on the DVD recorder to open the disc tray.
3)Insert the disc but do not close the tray.
4)Hold down button number {5} on the remote control until the tray closes. The DVD recorder will start the repair process.
5)If the disc is recovered, the Picture Index screen will appear.
Please observe the following:
–Error during recording : The title may be missing.
–Error while changing the title/index picture : The original title/ index picture may be visible.
–Error while finalising : The disc appears not to have been finalised.
–You can finalise the disc using the following function:
1) Press OPEN/CLOSE on the DVD recorder to open the disc tray.
2) Insert the disc but do not close the tray.
3) Hold down button number {4} on the remote control until the tray closes. ‘FINALISING' appears on the display panel.
4) If finalising has been successful, the Picture Index screen will appear.
–This happens if you try to copy DVDs or video cassettes that have been
–The DVD+R(W) has recording lifetime, please change a new disc for recording.
–Check that the cable is plugged in firmly.
–If a recording is made from a video recorder, change the tracking on the video recorder.
–The DVD recorder may not be able to recognise the video input signal if this signal is poor or does not comply with relevant standards.
64
3139 246 13454
1DVDR6xx_Eng00_13454c | 64 | 9/28/04, 1:26 PM |
