[ Digital Audio ]
Select the setting based on the digital ampli er/receiver that is connected through the digital jack.
•[ Digital Output ] – select the type of digital output.
Option | Description |
[ Off ] | Disable digital output. |
|
|
[ All ] | The device supports |
| |
| formats. |
[PCM Only ] The device is not capable of decoding
•[ LPCM Output ] – select the LPCM (Linear Pulse Code Modulation) output sampling rate.
Option Description
[48kHz ] For discs recorded at sampling rate of 48 kHz.
[96kHz ] For discs recorded at the sampling rate of 96 kHz.
Note
•[ LPCM Output ] setting is only available if the [ Digital Output ] is set to [ PCM only ].
•The higher the sampling rate, the better the sound quality.
[ Volume ]
Set the default volume level when you play
adisc.
1.Press OK.
2.Press b B to set the volume.
3.Press OK to con rm and exit.
[ Sound Mode ]
Select a preset sound effect to enhance the audio output.
•[ 3D ] – select a virtual surround sound effect that is produced from the left and right audio channels.
•[ Movie Mode ] – select a sound effect for movies.
•[ Music Mode ] – select a sound effect for music.
[ Speaker Setup ]
When you connect a speaker system, you can optimize surround output for the connected speakers.
•[ Front Speaker ]
Option | Description |
[ Large ] | Produce low frequency |
| signal below 120 Hz. |
[ Small ] | Cannot produce low |
| frequency signal below |
| 120 Hz. |
|
|
Adjust settings
27
