Quick start
This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is reopened.
≥When in quick start standby mode about
60% ( 
/ 
: about 70%) of the power used in recording pause mode is being consumed, so the recording time will be reduced.
¬Change the mode to 
.
1 Select the menu. (l 27)
[SETUP] # [QUICK START] # [ON]
2 Close the LCD monitor while the mode is set to 
.
The status indicator A flashes green and the unit goes into quick start standby mode.
≥The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put into recording pause.
≥Quick start standby mode is cancelled if jabout 5 minutes elapsed
jmode is set to 
junit is turned off
≥Time for quick start will be more than
0.6 seconds slower when digital cinema is used.
≥It may take some time for automatic white balance to adjust.
≥In the quick start mode, the zoom magnification becomes 1k.
≥If [ECONOMY] (l 29) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and then open it again.
≥Quick Start Standby Mode cannot be released by the remote control. Turn the mode to OFF when powering off.
42
VQT2B30