Geometry Default Values
Mode 1
480p Mode 2
1080i Mode 3
1080i, Comp
Wide blank 7 7 7
Horizontal Shift 24 21 21
Horizontal Para 8 8 8
E-W Width 31 44 44
E-W Para 45 45 45
E-W Trap 31 31 31
Horizontal Bow 7 7 7
Vertical Slope 40 33 33
Vertical Amp 40 40 12
S Correction 31 31 31
Vertical Shift 31 31 31
Fast Blank 0 1 1
To exit the Service Alignment Mode (SAM), press the Menu key to return to the main SAM menu. Then turn the
set Off.
Convergence Alignment
To enter the Convergence Alignment mode, press 0, 6, 2, 5, 9, 7, Index on the Remote Control. Listed below is
a map of the Convergence menus. Make sure that a signal is applied to the set for the mode being adjusted.
Make sure that the set is in the mode you wish to adjust before entering the Convergence Alignment mode.