Philips MCD288/05 Clock setting, Timer setting, Sleep timer setting, To deactivate the timer

Clock/Timer

English

Clock setting

To deactivate the timer

See "Preparations-Step 2: Setting the clock".	● Press SLEEP/TIMER again.
	➜	disappears.

Timer setting

●The system can be used as an alarm clock, whereby the last selected source is switched on at a set time (one time operation).The clock time needs to be set first before the timer can be used.

1In standby mode, press and hold SLEEP/ TIMER for more than three seconds.

➜ "TIMER SET" is displayed briefly.Then, the hour digits flash on the display panel.

2Press VOLUME -/+ (VOL +/- on the remote) to set the hours and SLEEP/TIMER to confirm.

➜ The minute digits flash on the display panel.

3Press VOLUME -/+ (VOL +/- on the remote) to set the minutes and SLEEP/TIMER to confirm.

➜ "TUN", “DVD” or "USB" flashes.

4Press VOLUME -/+ (VOL +/- on the remote) to select your desired source.

5Press SLEEP/TIMER to complete the setting. ➜ Display shows .

Sleep timer setting

The sleep timer enables the system to switch off by itself after a set period of time.

1Press SLEEP/TIMER on the remote control repeatedly to select a preset time.

➜The selections are as follows (time in minutes):

OFF ™ 15 ™ 30 ™ 45 ™ 60 ™ 75 ™ 90 ™ 105 ™ 120 ™ OFF

➜"SLEEP XX" or "SLEEP OFF" is displayed.

"XX" is the time in minutes.

2When you reach the desired length of time, stop pressing SLEEP/TIMER.

➜ Display shows .

To deactivate the sleep timer

●Press SLEEP/TIMER repeatedly until "00" is displayed, or press STANDBY-ONy (STANDBY y on the remote).

➜ disappears.

37