within the specified range. The Message Center will adjust the specified rate to the nearest available supported rate.
4.2.5 Enable /INT Signal Monitor
Monitor/INT (on INT supported adapters only. Default=OFF)
Enable /INT signal monitoring.
4.2.6Stop On Busy StopOnBusy (Default=OFF)
Stop sending I2C messages if the adapter returns a "Busy" response to the host computer.
4.2.7Stop On Arbitration Loss StopOnArbLoss (Default=OFF)
Stop sending I2C messages if the adapter returns a "Bus Arbitration Loss" response to the host computer. Bus Arbitration Loss occurs when another I2C Bus master wins arbitration while the adapter is attempting to become a bus master.
4.2.8Stop On Slave Negative Acknowledgment StopOnNak (Default=OFF)
Stop sending I2C messages if the adapter returns a "Slave Not Acknowledging" response to the host computer. Slave Not Acknowledging occurs when the adapter is attempting to become a bus master and no slave device acknowledges the transmitted slave address.
4.2.9Beep On Busy BeepOnBusy (Default=OFF)
Generate a host computer beep if the adapter returns a "Busy" response to the host computer.
25
