Troubleshooting
Problem
The DVD player does not start playback.
Cannot activate some features, such as Angles, Subtitles, or
There is no sound from the center and rear speakers.
Radio reception is poor.
The remote control does not function properly.
The display panel is dark.
Low hum or buzz sound.
Solution
–Insert a readable disc with the playback side facing down. The
–Check the disc type, color system and region code. (see page 22)
–Check for any scratches or smudges on the disc.
–Press SYSTEM SETUP to turn off the setup menu screen.
–You may need to enter the password in order to change the parental control rating level or to unlock the disc for playback. (see page 30)
–Moisture has condensed inside the system. Remove the disc and leave the system turned on for about an hour.
–The features may not be available on the DVD.
–Changing the language for the sound or subtitle is prohibited on the DVD.
–Press CENTER +- or REAR +- to adjust the volume level. (see page 20)
–Make sure the center and rear speakers are connected correctly. (see page 11)
–Press SURROUND button to select a correct surround sound setting. (see page 33)
–Make sure the source you are playing is recorded or broadcast in surround sound (DPL II, Dolby Digital, etc.)
–If the signal is too weak, adjust the antenna or connect an external antenna for better reception.
–Increase the distance between the system and your TV or VCR.
–Tune in to the correct frequency.
–Place the antenna farther away from any equipment that may be causing the noise.
–Select the source (DISC or TUNER, for
example) before pressing the function button (ÉÅ, S, T.)
–Reduce the distance between the remote control and the system.
–Replace the batteries with new ones.
–Point the remote control directly toward the IR sensor.
–Check that the batteries are loaded correctly.
–Press DIM again. (see page 33)
–Place the DVD system as far away as possible from electrical devices that may be causing interference.
E n g l i s h
37
