Philips SCD464 user manual EN Getting your baby monitor ready, Using your baby monitor

EN Getting your baby monitor ready

Battery operated use

1Remove the battery compartment cover (B-11) of the parent unit, by sliding down the cover

2Insert three 1,5V AAA batteries, noting the + and – configuration inside the battery compartment (batteries are not supplied, we recommend Philips Alkaline batteries)

3Slide the battery compartment cover (B-11) back in place until it clicks in position

➜The parent unit is now ready for battery operated use.

Using your baby monitor

1Position both units in the same room to test the connection. Make sure the baby unit is at least 1 meter / 3 feet away from the parent unit.

2Press the ON/OFF button (A-1) to switch on the baby unit.

>The POWER light (A-6) lights up green.

3Switch on the parent unit using the ON/OFF switch (B-9) and adjust the volume to the level you prefer using the VOLUME control (B-9).

>The POWER light (B-9) lights up green.

>When connection has been established between the units, the LINK light (B-3) on the parent unit lights up green.

8