Troubleshooting EN

Problem

Possible cause

Solution

POWER light (A-6, B-9) Unit not switched on. does not light.

AC power adapter (A-3, B-5) not connected to the

DC 9V —<+power supply jack (A-2, B-4).

AC power adapter (A-3, B-5) not connected to the power supply.

Batteries low.

Press On/Off button (A-1) or set On/Off switch (B-8) to ON.

Connect AC power adapter (A-3, B-5) to the DC 9V —<+power supply jack (A-2, B-4).

Connect AC power adapter (A-3, B-5) to a wall outlet.

Replace batteries.

POWER light (A-6, B-9)

Batteries low.

Replace batteries.

is blinking.

 

 

 

 

 

High pitched noise.

Units too close to each other.

Move parent unit away from baby

 

 

unit (at least 1 metre / 3 feet).

 

Volume set too high.

Turn ON/OFF switch /

 

 

VOLUME control (B-8) upwards.

 

 

 

Pick-up from another

Both systems are operating

Switch channels (A-8, B-7).

baby monitor.

on the same frequency.

Make sure both units are set

 

 

to the same position.

LINK light (B-3)

Units are out of range.

Move units closer together.

flashing red / LINK

 

 

alarm beeps.

Interference from another

Switch to a different channel

 

baby monitor.

(A-8, B-7).

 

Interference from another

Remove other FM source.

 

FM source.

 

13

Page 13
Image 13
Philips SCD464 user manual Troubleshooting EN, Unit at least 1 metre / 3 feet, Volume set too high Turn ON/OFF switch