Philips SCD468 user manual Frequently asked questions EN, QuestionAnswer, Full capacity again

Frequently asked questions EN

QuestionAnswer

Why does a new rechargeable battery pack has no full operating time capacity after the first charge?

It takes about 3 times full recharge and discharges before the rechargeable NiMH batteries have their full capacity available.

My rechargeable battery pack	Leaving the rechargeable battery pack continuously connected
has very short duration, why?	to a charging unit can shorten it’s lifetime. If the product is not
	used for some time, the charged battery pack slowly looses it’s
	load.This is normal; a short recharge will bring it back to it’s
	full capacity again.

The charging light (B-6) on the parent unit charging base (B-5) remains lit red, even after the full charge duration.Why?

When installed on the charging base, the parent unit cannot be switched on immediately.

Parent unit reacts too slow/ late on baby's cry.

Parent unit reacts too quick on other ambient sounds.

The link is lost every now and then, sound interruptions etc.

The charging light (B-6) is always activated as soon as the parent unit is installed. It gradually dims when the batteries are fully charged but remains lit, indicating that the parent unit is powered.

At this point your battery is probably completely empty.

After some 30 minutes of charging it will be possible to switch the parent unit on, while installed on the charging unit.

Set microphone sensitivity on the baby unit to a higher level and/or move the baby unit closer to the baby (keep minimal distance of 1 meter / 3 feet).

Set microphone sensitivity on the baby unit to a lower level and/or move the baby unit closer to the baby (keep minimal distance of 1 meter / 3 feet).

You are probably approaching the outer boundaries of the practical range.Try a different location or reduce the distance slightly. Please note that it takes about 30 seconds each time before a new link is established.

13