Philips SCD468 user manual EN Troubleshooting, Problem Possible cause Solution, Tansmitted signal

EN Troubleshooting

Problem	Possible cause	Solution
No sound on parent unit.	Volume off or too low.	Turn VOLUME control (B-9) on
		parent unit downwards.
	Units out of range.	Move parent unit closer to baby
		unit.

No connection	Units are set to different
between units.	channels.
	Parent unit out of range of
	tansmitted signal.
Battery pack does	Battery life at an end.
not charge.

Set channel selection switches (A-9, B-11) to the same position on both units.

Move parent unit closer to baby unit.

Replace battery pack (B-14) of parent unit.

Interference or	Mobile or cordless phone(s)
poor reception.	too close to baby monitor.
	Interference from other
	baby monitors in the
	neighborhood.
	Battery power running low.
	Transmitted signal is out of
	range; e.g. there are too many
	walls and/or ceilings between
	baby unit and parent unit.

Move phone(s) away from baby monitor.

Switch both units to another channel using the channel selection switch (A-9, B-11)

Recharge battery pack in time.

Move parent unit closer to baby unit.

Parent unit located too close to a window and picking up interfering signals from other appliances.

Move parent unit away from window.

LINK light (B-9)	Units are out of range.	Move units closer together.
flashing red / LINK
alarm (B-8) beeps.	Interference from another	Switch to a different channel
	baby monitor.	(A-9, B-11).
	Interference from another	Remove other FM source.
	FM source.

12