8ENGLISH

-- Never drop or insert any foreign object into any opening.

-- Although the breast pump is compliant with applicable EMC directives, it may still be susceptible to excessive emissions and/or may interfere with more sensitive equipment.

-- Never use any accessories or parts from other manufacturers or that Philips AVENT does not specifically recommend. If you use such accessories or parts, your guarantee becomes invalid.

-- Clean, rinse and sterilise all pump parts, except the motor unit, the tube and cap and the adapter before each use.

-- Never put the motor unit or the adapter in water or in a steriliser, as this causes permanent damage to these parts.

-- Do not use antibacterial or abrasive cleaning agents when you clean breast pump parts.

-- Do not use the breast pump if the silicone diaphragm appears to be damaged or broken. See chapter ‘Ordering accessories’ for information on how to obtain replacement parts.

-- Do not continue pumping for more than five minutes at a time if you do not succeed in expressing any milk.

-- If the pressure generated is uncomfortable or causes pain, switch off the appliance, break the seal between the breast and the pump body with your finger and remove the pump from your breast.

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields.

Preparing for use

The motor unit, the silicone tube and cap and the adapter do not require cleaning and sterilising, as they do not come into contact with breast milk.

Clean and sterilise all other parts of the breast pump before first use as described in chapter ‘Cleaning and sterilising’. Also clean these parts after each subsequent use and sterilise them before each subsequent use.

Assembling the breast pump

Note: Make sure you have cleaned and sterilised the appropriate parts of the breast pump.Wash your hands thoroughly before you handle the cleaned parts.

Be careful, the cleaned parts may still be hot.

Tip:You may find it easier to assemble the breast pump while it is wet.

1Insert the white valve into the pump body from underneath. Push in the valve as far as possible (Fig. 2).

2Screw the pump body clockwise onto the bottle until it is securely fixed (Fig. 3).

Page 8
Image 8
Philips SCF334, SCF332 manual Electromagnetic fields EMF, Preparing for use, Assembling the breast pump