Installation & User’s Manual | PLCYC LED Luminaires |
|
|
4. Mounting
PLCYC LED Luminaires offer a plastic monocoque yoke design for mounting by theatrical clamps or hooks (sold separately).
For optimum performance and use, PLCYC LED Luminaires should be mounted and spaced as shown in Figure 5.
How to read Figure 5:
•S = Spacing between fixtures
•D = Distance from fixture to projection surface.
•A ratio of S = D x 0.9 is the formula used to cal- culate the optimum spacing for these fixtures.
WARNING! Before attempting any installation or service, disconnect all power at power source. Turning off the output of the luminaire does not disconnect power. Installation and service should only be performed by a trained and qualified professional. Be sure to check circuit capacity before installing luminaires.
S D
Figure 5: PLCYC LED Luminaire Hanging / Spacing
5. Tilt Adjustments
To adjust luminaire tilt position:
Step 1. As shown in Figure 6, at tilt locking handle, loosen handle by twisting to the left.
Yoke Assembly
Tilt Locking Handle
Luminaire
Head Assembly
1.2 in. / | 9.5 in. / | |
240.4 mm | ||
30.2 mm | ||
| ||
6.7 in. / |
| |
170.5 mm |
| |
R 5.7 in. / |
| |
143.5 mm |
| |
R 7.7 in. / |
| |
195.0 mm |
|
Figure 6: Tilt Adjustments
Step 2. Position tilt (up or down) luminaire head assembly as desired. Step 3.
8INSTALLATION AND SET UP