Philips SJM3152/17 manual Starting up an activity, Device appear in the display screen, Tip

DNote

Other installed devices use the functions that are labeled on the remote. Check your original remote when you are not sure.

To switch back to your iPod™ playlist after controlling another device with your universal remote for iPod™, press the iPod™ launch key.

4.4 Starting up an activity

An activity is a sequence of key presses that you can program. For example, for watching a DVD you normally would have to:

1.Turn on the TV;

2.Turn on the DVD;

3.Turn on the surround sound system;

4.Select the right input on your TV and surround sound system;

5.Press the PLAY key to start the DVD.

By selecting the activity “Watch DVD” on the universal remote for iPod™, all the actions are automatically executed in the predefined sequence.

Starting up an activity:

1.Press MODE key repeatedly until the activity name appears in the header of the display screen.

2.Confirm your selection by pressing OK. The activity will begin immediately.

You can add up to 8 activities to your universal remote for iPod™. For more information about adding and deleting activities, see section

5.5, Adding an activity and section

5.6, Deleting an activity.

Selecting extra functions

Devices may have extra functions that are not covered by the hard keys on your universal remote for iPod™.You can select these extra functions in the display.

1.While in any device mode, Press MAIN VOL key. Extra functions for the selected

device appear in the display screen.

2.To scroll through all the extra functions, press the cursor up or cursor down key.

3.When you find the selection you want,

press OK.The remote sends out an IR signal.

For adding extra functions to your universal remote for iPod™, see section 5.4,Adding a function.

ETip

If you cannot find the extra function you are looking for, you can exit the Extra menu by pressing the MAIN VOL key again.

DNote

Some devices do not have any extra functions available in the remote’s data base. However, you can easily copy additional functions from your original remote by learning keys. See section 5.4,Adding a function.

4.5 Replacing the batteries

BWarning

When you replace the batteries, do not mix different brands of batteries or place zinc carbon batteries in the remote.This can trigger unpredictable behavior.

When the batteries are almost empty, the “Battery Low” icon appears. Replace the batteries with new LR6 or AA type alkaline batteries. Follow the local regulations for disposal of the empty batteries.

ENGLISH

Getting Started 15