Philips Universal 3 manual Add a specific function to your remote control

TV VCR SAT

16

9 9 3

Instructions for use

1 Press the mode selector key to select VCR.
2 Press and hold keys 1 and 6 simultaneously -for about 3	English
3 On the keypad, press keys 9, 9, and 3.
seconds - until the green LED lights up.

4 Press the mode selector key to select SAT (second TV). 5 Press the power key.

–That’s it! The LED flashes twice to indicate successful set up. The Volume up/down keys now control the volume of your second (SAT) TV when you’re in VCR mode.

TV	VCR	SAT
1		6
9	9	4
0	-	9

SHIF T

Add a specific function to your remote control

In case you do not find the function you want to use (e.g. a specific teletext function), it can easily be added to your remote control’s functionality. All you have to do is contact the Philips Universal Remote Control helpline to obtain the 3- digit code for the missing function. The rest of the procedure is quite simple:

1 Press the mode selector key for the device you want to operate.

2 Press and hold keys 1 and 6 simultaneously - for about three seconds - until the green LED lights up.

3 Enter 9, 9 and 4, using the number keys.

4 Enter the 3-digit code you received from the helpline using the number keys, within 30 seconds.

5 Press the key under which you want to store the new function. The LED flashes twice to indicate a succesfull installation.

If you want to store the function under a Shift/Key combination; first press Shift, then press the required function key.

N O T E

-The original function of the key will be overwritten. If you want to return to its original function see the following section about resetting.

-Remember: no functions can be performed by this remote control that are not present on the equipment you are operating!

16

9 8 1

Reset your remote control to its original presets:

If you want to return to the original functions of all keys and delete all added functions under programmed keys a simple reset procedure is sufficient:

1 Press and hold keys 1 and 6 simultaneously - for about three seconds - until the green LED lights up.

2 Enter 9, 8 and 1, using the number keys.

-The LED flashes twice to indicate a succesfull reset. The keys on your remote control will now perform their default functions.

7