Philips Universal 3 manual Troubleshooting Guide, Solution, Try the hands-free Autosearch method

Instructions for use

English

0 0

6 4

16

9 8 1

TROUBLESHOOTING GUIDE

•Problem:

– Solution:

•Device is not responding and the green light does not flash when you press a button.

–Replace batteries with two new 1.5 volt, type RO3, UM4 or AAA batteries.

•Device is not responding, but the green light does flash when you press a button.

–Aim the SBC RU530 at the device and be sure that there are no obstructions between the SBC RU530 and the device.

• The SBC RU530 is not performing commands properly.

–You may be using the wrong code. Try repeating Set up using another code, listed under your brand, or start the Autosearch Set-up over again to locate the proper code.

If the device still doesn’t respond, call the help-line and we’ll put you back on track.

•You can’t access teletext pages and you were used to use this (fi) button to access teletext.

–Follow Set up procedure and at step 5 of section “Your equipment is of another brand, or your equipment is a Philips brand, but not all keys respond correctly” press keys

0, 0, 6 and 4.

To enter teletext pages, press the teletext cancel button.

• The teletext buttons do not work.

–Be sure your TV has teletext capabilities. The SBC RU530 does not extend the capabilities of your TV!

•Having problems operating all the functions on your device.

– The SBC RU530 may just need customising for your model type. Just call our help-line and we’ll put you back on track.

•Your brand is not listed in the code list.

– Try the hands-free Autosearch method.

•You want to reset the remote control to its factory preset.

– 1 Press and hold keys 1 and 6 simultaneously - for about 3 seconds - until the green LED lights up.

– 2 On the keypad, press keys 9, 8, and 1.

The LED flashes twice to indicate a successful reset.

8