Helpful Hints (cont’d) 43

Tape cannot be removed.

Make sure the power plug is completely connected to an AC (alternating current) outlet.

You have set a timer recording. Turn on the VCR power, then eject the tape. Be sure to insert a tape and turn off the VCR for your timer recording.

Tape cannot be inserted.

Insert the tape, window side up, with the record tab facing you.

Make sure a tape isn’t already in the VCR by pressing the STOP/EJECT button on the VCR or the EJECT button on the remote control.

Gently push on the center of the tape when putting it in the VCR. Never force the tape into the VCR.

If a timer recording is set, the VCR will not accept a tape that does not have a record tab. You may only insert a tape with the record tab intact.

VCR ejects the tape when the RECORD button is pressed or when the VCR power is turned off to set a timer recording.

• Make sure the tape has a record tab. Details are on page five.

There is no playback picture, or the playback picture is noisy or contains streaks.

Make sure the TV is on the same channel as the VCR’s CH3/CH4 switch. Details are on page seven.

Make sure the VCR is in VCR position. (The VCR/TV light will appear. If it does not, press the VCR/TV button once.)

Make sure channel 3 or 4 is properly adjusted.

Adjust the tracking. Details are on page 41.

TVs placed too close to the VCR can cause interference during tape playback. Move the VCR away from the TV.

TV programs cannot be watched normally.

Press the VCR/TV button to put the VCR in TV position. (The VCR/TV light will disappear.)

Check the connections between the VCR, TV, antenna/cable, and Cable Box/DBS (if applicable). Details are on pages six-10.

The reception on all channels is poor.

• You may need to tune your TV again.

Line Input

If you accidentally enter Line Input mode (LineIn Rear (L1) will appear on your TV screen briefly), press the CHANNEL (o/p) buttons or use the Number buttons to select another channel.

The playback picture is too dim, too bright, or fluctuates in brightness.

Some programs may be broadcast with copyright protection technology in order to protect the rights of copyright owners. This technology is used on programs that are recorded on video tapes or Digital Video Discs (DVDs), as well as some programs broadcast by antenna/cable/satellite television channels. Programs broadcast with copyright protection technology may not record clearly. Likewise, if you play a tape that is a recording of a copyright protected program, the picture may not be clear. Tapes of copy- right protected programs may have a picture that is dark or dim, or the brightness of the picture may fluctuate. Therefore, you should avoid recording or playing copies of copyright protected programs. This VCR incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights own- ers. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only, unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Page 43
Image 43
Philips VR400BMG owner manual Helpful Hints cont’d