Philips WP3810, WP3811 manual Installation D-type adapter, Installing the filter cartridge

10English

2

3

4

-

1

2

3

4

Remove the aerator cap from the tap.Take out the original adapter and screw the matching adapter (C-type) onto the tap through the attachment nut. (Fig. 14)

Tighten the adapter further with a coin (Fig. 15).

Firmly screw the attachment nut onto the water purifier housing (Fig. 16).

Installation D-type adapter

For taps other than A, B or C. (Fig. 17)

Remove the attachment nut and the adapter from the water purifier housing (Fig. 18).

Take out the original adapter and screw the D-type adapter onto the water purifier housing. (Fig. 19)

Push the water purifier housing onto the tap from below and tighten the 4 screws evenly (Fig. 20).

Screw the attachment nut firmly onto the water purifier housing (Fig. 21).

Make sure the rubber washer is firmly pushed against the tap to prevent

water leakage.

Installing the filter cartridge

1

2

3

4

5

Make sure the tap is closed.

Set the water selection lever to the unfiltered stream position (Fig. 22).

Tilt the filter cartridge 90° backwards and insert it into the water purifier housing. (Fig. 23)

Pull the cartridge upwards until it is in upright position. (Fig. 24)

Air trapped inside the filter cartridge affects the flow rate of the filtered water.To avoid this, slightly open the tap and let water run through the filter cartridge for 30 seconds.The slow water flow forces out any air that is trapped inside the filter.