Basic operations

! When strange or incorrect messages appear on the display

1 Turn the ignition switch OFF.

2 Press RESET with a pen tip or other pointed instrument.

2Push on the bottom of the front panel until it clicks into place.

RESET button

Note

Switch your engine ON or set the ignition switch to ACC ON before pressing RESET in the following situations:

! After completing connections ! When erasing all stored settings

! When resetting the unit to its initial (factory) settings

Section

04

operations Basic

Setting the clock

1Switch to Clock Adjustment display. Refer to Basic operations on page 14.

2Select the item to set.

3Touch aor bto set the correct date and time.

Resetting the microprocessor

By pressing RESET, you can reset the microprocessor to its initial settings without changing the bookmark information.

The microprocessor must be reset in the following situations:

!Before using this unit for the first time after installation

!If the unit fails to operate properly

Demo mode

The feature demo automatically starts when you select Off for the source and continues while the ignition switch is set to ACC or ON. To cancel the feature demo, press and hold MUTE. Press and hold MUTE again to restart. Operating the feature demo while the car engine is turned off it may drain the battery power.

Important

Failure to connect the red lead (ACC) of this unit to a terminal coupled with ignition switch on/off operations may lead to battery drain.

En 19