Pioneer DEH-P3950MP Audio Adjustments Adjusting loudness, Using subwoofer output, Or decreased

Black plate (19,1)

Audio Adjustments

Adjusting loudness	# When the subwoofer output is on, you can se-
Loudness compensates for deficiencies in the	lect 80: 0.
	# If the subwoofer setting has been previously
low- and high-sound ranges at low volume.
	adjusted, the frequency of that previously se-
1 Press AUDIO to select LOUD.	lected will be displayed instead of 80.
2 Press a to turn loudness on.	2 Press c or d to select cut-off frequency.
	50—63—80—100—125 (Hz)
Loudness level (e.g., LOUD :MID) appears in
	Only frequencies lower than those in the se-
the display.
	lected range are outputted from the subwoo-
# To turn loudness off, press b.
	fer.
3 Press c or d to select a desired level.	3 Press a or b to adjust the output level
LOW (low)—MID (mid)—HI (high)
	of the subwoofer.
	+6 to –24 is displayed as the level is increased
Using subwoofer output	or decreased.
This unit is equipped with a subwoofer output
which can be turned on or off.	Using the high pass filter
1 Press AUDIO to select SUB.W.	When you do not want low sounds from the
# You can also select the subwoofer setting	subwoofer output frequency range to play
menu by pressing SW on the unit.	from the front or rear speakers, turn on the
# When the subwoofer controller setting is	HPF (high pass filter). Only frequencies higher
P/O :FUL, you cannot select SUB.W.	than those in the selected range are outputted
2 Press a to turn subwoofer output on.	from the front or rear speakers.
	1 Press AUDIO to select HPF.
SUB.W:NOR appears in the display. Subwoo-
fer output is now on.	# When the F.I.E. function is on, you cannot se-
# If the subwoofer output phase has been set to	lect HPF.
the reverse, SUB.W:REV will be displayed.	2 Press a to turn high pass filter on.
# To turn subwoofer output off, press b.
	HPF : 80 appears in the display. High pass fil-

Section

06

English

3Press c or d to select the phase of sub- woofer output.

Press c to select reverse phase and REV ap- pears in the display. Press d to select normal phase and NOR appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad- just the cut-off frequency and the output level of the subwoofer.

1 Press AUDIO to select 80: 0.

#You can also select the subwoofer setting menu by pressing SW on the unit.

ter is now on.

#If the high pass filter has been previously ad- justed, the frequency of that previously selected will be displayed instead of HPF : 80.

#To turn high pass filter off, press b.

3Press c or d to select cut-off frequency. 50—63—80—100—125 (Hz)

Only frequencies higher than those in the se-

lected range are outputted from the front or rear speakers.

En 19

<YRD5079-A/U>19