Pioneer DEH-P3950MP operation manual Other Functions Adjusting initial settings, Setting the clock

Black plate (21,1)

Other Functions

Adjusting initial settings	3 Press a or b to set the clock.
	Pressing a will increase the selected hour or
1	minute. Pressing b will decrease the selected
	hour or minute.

Section

07

English

Using the initial settings, you can customize various system settings to achieve optimal per- formance from this unit.

1Function display Shows the function status.

1Press SOURCE and hold until the unit turns off.

2Press SOURCE and hold again until the clock appears in the display.

3Press FUNCTION to select one of the in- itial settings.

Press FUNCTION repeatedly to switch be- tween the following settings:

Clock—FM (FM tuning step)—AM (AM tuning step)—AUX1 (auxiliary input 1)—AUX2 (aux- iliary input 2)—R-SP (rear output and subwoo- fer controller)

Use the following instructions to operate each

particular setting.

# To cancel initial settings, press BAND.

# You can also cancel initial settings by holding down SOURCE until the unit turns off.

Setting the clock

Use these instructions to set the clock.

1Press FUNCTION to select clock.

2Press c or d to select the segment of the clock display you wish to set. Hour—Minute

As you select segments of the clock display the segment selected will blink.

Setting the FM tuning step

The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz.

1Press FUNCTION to select FM.

2Press c or d to select the FM tuning step.

Pressing c or d will switch the FM tuning step between 100 kHz and 50 kHz. The se- lected FM tuning step will appear in the dis- play.

Note

If seek tuning is performed in 50 kHz steps, sta- tions may be tuned in imprecisely. Tune in the sta- tions with manual tuning or use seek tuning again.

Setting the AM tuning step

The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable).

1Press FUNCTION to select AM.

2Press c or d to select the AM tuning step.

Pressing c or d will switch the AM tuning

step between 9 kHz and 10 kHz. The selected AM tuning step will appear in the display.

En 21

<YRD5079-A/U>21