Section
01
Before You Start
!If the front panel is not detached from the head unit within five seconds of turning off the ignition, a warning tone sounds.
!You can turn off the warning tone. See Switching the warning tone on page 29.
Important
!Handle gently when removing or attaching the front panel.
!Avoid subjecting the front panel to excessive shock.
!Keep the front panel out of direct sunlight and high temperatures.
Removing the front panel
1Press DETACH to release the front panel.
2Grab the front panel and remove.
Attaching the front panel
1Slide the front panel to the left until it clicks.
Front panel and the head unit are jointed on the left side. Make sure that the front panel has been jointed to the head unit.
2Press the right side of the front panel
until it is firmly seated.
# If you can’t attach the front panel to the head unit successfully, try again. Front panel may be damaged if you attach the front panel forcedly.
8 | En |
About the demo mode
This unit features the feature demo mode.
Important
!The red lead (ACC) of this unit should be con- nected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained.
!Before detaching, be sure to remove the AUX cable from the front panel. Otherwise, this unit, connected device or vehicle interior may be damaged.
Feature demo mode
The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON. Press DISP during feature demo operation to cancel the feature demo mode. Press DISP again to start. Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power. 
Use and care of the remote control
Installing the battery
Slide the tray on the back of the remote con- trol out and insert the battery with the plus (+) and minus
!When using for the first time, pull out the film protruding from the tray.
