Pioneer DEH-P410UB Initial Settings Adjusting initial settings, Switching the warning tone

Section

Initial Settings

Adjusting initial settings		4 Turn MULTI-CONTROL to put a clock
1	Press SOURCE and hold until the unit	right.
		# You can also perform the same operations by
turns off.
		pushing MULTI-CONTROL up or down.
2	Press MULTI-CONTROL and hold until
CLOCK SET appears in the display.		Switching the warning tone

04

English

3Turn MULTI-CONTROL to select one of the initial settings.

CLOCK SET (clock)—WARNING TONE (warn- ing tone)—AUX1 (auxiliary input 1)—AUX2 (auxiliary input 2)—DIMMER (dimmer)— SW CONTROL (rear output and subwoofer controller)—DEMO (feature demo)—

EVER SCROLL (ever scroll)—BT AUDIO (Blue- tooth audio)—PIN CODE INPUT (pin code input)—BT VER INFO (Bluetooth version infor-

mation)

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

# You can also select the function by pressing

FUNCTION on the remote control.

# To cancel initial settings, press BAND/ESC.

# BT AUDIO, PIN CODE INPUT and

BT VER INFO can be selected only when Blue-

tooth adapter (e.g., CD-BTB200) is connected to this unit.

Setting the clock

Use these instructions to set the clock.

1Use MULTI-CONTROL to select CLOCK SET in the initial setting menu.

2Press MULTI-CONTROL to display the setting mode.

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone.

1Use MULTI-CONTROL to select

WARNING TONE.

2Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 32.

1Use MULTI-CONTROL to select AUX1/ AUX2.

2Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL again.

#Press BACK to return to the previous display.

3Press MULTI-CONTROL to select the seg- ment of the clock display you wish to set. Each time you press MULTI-CONTROL, one segment of the clock display is selected. Hour—Minute

As you select segments of the clock display, the selected segment blinks.

Switching the dimmer setting

To prevent the display from being too bright at night, the display is automatically dimmed when the car’s headlights are turned on. You can turn the dimmer on or off.

1 Use MULTI-CONTROL to select DIMMER.

En 29

<YRD5266-B/S>29