Pioneer DEH-P7400MP operation manual Using non fading output, Adjusting subwoofer settings

Section

Audio Adjustments 07

Adjusting subwoofer settings

When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer.

1Press AUDIO to select the Sub-W2. When the subwoofer output is on, you can select the Sub-W2. Press AUDIO until Sub-W2 80 (Hz) appears in the display.

• If the subwoofer setting has been previously adjusted, the frequency of that previously selected will be displayed, such as 50 (Hz) or 125 (Hz).

2Press 2 or 3 to select cut-off frequency. Press 2 and 50 (Hz) is displayed. Press 3 and

125(Hz) is displayed. Only frequencies lower than those in the selected range are output from the subwoofer.

3Press 5 or ∞ to adjust the output level of the subwoofer.

Each press of 5 or ∞ increases or decreases the level of the subwoofer (e.g., +6 to –6). Press 5 or ∞ until you see the desired value displayed.

Using non fading output

When the non fading output setting is on, the audio signal does not pass through this unit’s low pass filter (for the subwoofer), but is output through the RCA output.

1Press AUDIO to select non fading output on/off mode.

When the subwoofer controller setting is S.W Control:EXT, you can select non fading output on/off mode. Press AUDIO until NonFad ON appears in the display.

2Press 5 to turn non fading output on.

NonFad ON appears in the display. non fading output is now on.

• You can turn off non fading output by pressing

∞.

Adjusting non fading output level

When the non fading output is on, you can adjust the level of non fading output.

1Press AUDIO to select non fading output setting mode.

Press AUDIO until NonFad 0 appears in the dis- play.

2Press 5 or ∞ to adjust the output level of the non fading.

Each press of 5 or ∞ increases or decreases the level of the non fading (e.g., +6 to –6). Press 5 or ∞ until you see the desired value displayed.

English

Español

Deutsch Français Italiano

Nederlands

En 35