Section
08Initial Settings
Switching the auxiliary setting
It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit.
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX appears in the display.
2 Select AUX on or off with 5/∞.
Pressing 5/∞ will switch AUX between on and off and that status will be displayed (e.g., AUX :ON). 
Switching the dimmer setting
To prevent the display from being too bright at night, the display is automatically dimmed when the car’s headlights are turned on. You can switch dimmer on or off.
1 Press FUNCTION to select DIM.
Press FUNCTION repeatedly until Dimmer appears in the display.
2 Select DIM on or off with 5/∞.
Pressing 5/∞ will switch Dimmer between on and off and that status will be displayed (e.g.,
Dimmer :ON). 
Selecting the brightness
You can select the display brightness. Initially this mode is set to 12.
1Press FUNCTION to select BRIGHT. Press FUNCTION repeatedly until Brightness appears in the display.
2Select the desired brightness with 2/3.
• The display shows 0 – 15. 
Setting the rear output and sub- woofer controller
This product’s rear output (rear speaker leads output) can be used for
Initially, the unit is set for rear
When rear output are connected to full range speakers (when Rear SP:FULL is selected), you can connect the RCA subwoofer output to a subwoofer. In this case, you can select whether to use the subwoofer controller’s (low pass filter, phase)
38En
