Onlyfrequencies lower than those in the se-
lectedrange are outputted from the subwoo-
fer.
3 PushMulti-Control up or down to ad-
justthe output level of the subwoofer.
Eachpushing Multi-Control up or down in-
creasesor decreases the level of thesubwoo-
fer.+6 6is displayed as the level is
increasedor decreased.
Using nonfading output
Whenthe nonfading output setting ison, the
audiosignal does not pass through this units
lowpass filter (for the subwoofer), but is out-
puttedthrough the RCA output.
1 UseMulti-Control to select nonfading
outputon/off setting.
ONappears in the display.
#Whenthe subwoofer controller setting is only
Preout:FULL, you can switch to the nonfading
outputon/off setting. (Refer to page 50.)
2 PressMulti-Control to turn nonfading
outputon.
ONappears in the display. Nonfading output
isnow on.
#Toturn nonfading output off, press
Multi-Controlagain.

Adjusting nonfading output level

Whenthe nonfading output is on, you can ad-
justthe level of nonfading output.
1 UseMulti-Control to select nonfading
outputsetting.
0appearsin the display.
2 PushMulti-Control up or down to ad-
justthe nonfading output level.
Eachpushing Multi-Control up or down in-
creasesor decreases the level of thenonfad-
ingoutput. +6 6is displayed as the level is
increasedor decreased.
Using the high pass filter
Whenyou do not want low sounds fromthe
subwooferoutput frequency range to play
fromthe front or rear speakers, turn on the
HPF(high pass filter). Only frequencies higher
thanthose in the selected range are outputted
fromthe front or rear speakers.
1 UseMulti-Control to select HPF.
HPFappears in the display.
2 PressMulti-Control to turn high pass fil-
teron.
80Hzappears in the display. High pass filter is
nowon.
#Toturn high pass filter off, press
Multi-Controlagain.
3 PushMulti-Control left or right to select
cut-offfrequency.
Eachpushing Multi-Control left or right se-
lectscut-off frequencies in the following order:
50Hz80Hz125Hz
Onlyfrequencies higher than those in the se-
lectedrange are outputted from the front or
rearspeakers.
Adjusting source levels
SLA(source level adjustment) lets you adjust
thevolume level of each source to prevent ra-
dicalchanges in volume when switching be-
tweensources.
Audio Adjustments
En
46
Section
10