Pioneer DEH-P7900BT operation manual Adjusting loudness, Using subwoofer output

Section

02Operating this unit

+6 to –4 (or –6) is displayed as the equalizer curve is increased or decreased.

#The actual range of the adjustments are differ- ent depending on which equalizer curve is se- lected.

#The equalizer curve with all frequencies set to 0 cannot be adjusted.

Adjusting 7-band graphic equalizer

For Custom 1 and Custom 2 equalizer curves, you can adjust the level of each band.

!A separate Custom 1 curve can be created for each source. (The built-in CD player and the multi-CD player are set to the same equalizer adjustment setting automati- cally.) If you make adjustments when a curve other than Custom 2 is selected, the equalizer curve settings will be memorized in Custom 1.

!A Custom 2 curve can be created common to all sources. If you make adjustments when the Custom 2 curve is selected, the Custom 2 curve will be updated.

1Recall the equalizer curve you want to adjust.

See Recalling equalizer curves on the previous page.

2Use MULTI-CONTROL to select 7-band graphic equalizer adjustment.

Frequency and the level (e.g., 50Hz +4) ap- pears in the display.

3Push MULTI-CONTROL left or right to select the equalizer band to adjust.

Each time MULTI-CONTROL is pushed left or right, equalizer bands are selected in the fol- lowing order:

50Hz—125Hz—315Hz—800Hz—2kHz— 5kHz—12.5kHz

4Push MULTI-CONTROL up or down to adjust the level of the equalizer band. Each time MULTI-CONTROL is pushed up or down, the level of the equalization band in- creases or decreases.

+6 to –6 is displayed as the level is increased or decreased.

#You can then select another band and adjust the level.

5Press BAND to cancel the 7-band gra- phic equalizer adjustment.

Adjusting loudness

Loudness compensates for deficiencies in the low- and high-sound ranges at low volume.

1Use MULTI-CONTROL to select LOUD.

2Press MULTI-CONTROL to turn loudness

on.

Loudness level (e.g., Mid) appears in the dis-

play.

# To turn loudness off, press MULTI-CONTROL again.

3Push MULTI-CONTROL left or right to select a desired level.

Each time MULTI-CONTROL is pushed left or right, level is selected in the following order: Low (low)—Mid (mid)—High (high)

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off.

1Use MULTI-CONTROL to select Sub W.1.

2Press MULTI-CONTROL to turn subwoo- fer output on.

Normal appears in the display. Subwoofer out-

put is now on.

# To turn subwoofer output off, press MULTI-CONTROL again.

3Push MULTI-CONTROL left or right to select the phase of subwoofer output. Push MULTI-CONTROL left to select reverse phase and Reverse appears in the display. Push MULTI-CONTROL right to select normal phase and Normal appears in the display.

42 En