Runco DTV-947 manual Picture Quality Adjustments, Menu Description and Navigation

MENU DESCRIPTION AND NAVIGATION

Aspect Ratio allows selection of one of the three aspect ratios provided by the controller. You have two options for selecting an aspect ratio: First, highlight ASPECT RATIO on the main menu, then press ENTER. Then select the desired aspect ratio, and again press ENTER. The second option is to simply press the UP or DOWN arrows on the remote or front panel. Doing this will toggle you through the three choices- Anamorphic (16:9), Letterbox and Standard (4:3). For more infor- mation on aspect ratios, please refer to Page 11-18.

Pass Through Setup: The settings for this will tell the projector which source (RGB or Component) and aspect ratio to ‘look at’ when using the pass-through connectiion on the Controller. For example, if using a computer via the Pass-Through port on the Controller, this setting should be ‘Computer’. However, if a DTV decoder with a com- ponent output is used, the setting should be on ‘YUV HDTV’.

Picture Quality Adjustments

MAIN MENU

> COMPOSITE		ADJUST
	S-VIDEO
	COMPONENT
	PASS THROUGH

ASPECT RATIO

DISPLAY CONTROL

TINT COLOR BRIGHTNESS CONTRAST SHARPNESS LUMA ENHANCE CHROMA ENHANCE VCR MODE

Picture quality adjustments are those that change the various parameters of the image, such as COLOR (saturation level) and BRIGHTNESS (black level), among others. Typically, these adjustments should be made only once (during initial calibra- tion) and then left alone. However, if it is necessary to make any adjustments, per- form the following procedure:

In the example above, note that COMPOSITE is the active source. This is indicated by an arrow to the left of the word ‘COMPOSITE’. To make adjustments, highlight the active source (composite in this case) and press ENTER.

Note:

Pressing ENTER after highlighting a different source will switch you to that source instead of making picture quality adjustments.

11-15