Runco DTV-947 manual G2 Adjustment, CRT run in cycle, CRT RUN in Cycle Projector Warm UP

Service Mode

G2 Adjustment

Item is password protected.

Highlight ‘G2 adjust’ with the control disc and press ENTER to continue.

A safety notice will be displayed on the screen as it is necessary to open the top cover to adjust the G2.

COMMON SETTINGS

G2 ADJUSTMENT CRT RUN IN CYCLE PROJECTOR WARM UP MEMORYBANKS : ON

Select with or then <ENTER> <EXIT> to return.

ENTER selects the G2 adjustment.

EXIT returns to the Common settings menu.

ADJUST returns to the Operational mode.

‘G2 adjustment should be performed by RUNCO personnel, or RUNCO authorized dealers’.

If you are qualified, press ENTER to continue. If not qualified, press EXIT to return to the Common settings menu. Further description of the G2 adjustment is given in the Installation manual.

CRT run in cycle

The CRT run in cycle option can only be activated when memory blocks on an internal # pattern are available. When one or more such blocks are available, a flashing white image (5 sec on, 5 sec off) is generated and that for 5 minutes on the first internal block. In the next 5 minutes, a second internal block will be used to generate the flashing white image. The image will also be shifted in a vertical way to prevent a CRT burn in. To quit the CRT run in cycle option, press EXIT.

Highlight ‘CRT run in cycle’ with the control disc and press ENTER to start. ENTER selects the CRT run in cycle option.

EXIT returns to the Path Selection main menu.

COMMON SETTINGS

G2 ADJUSTMENT

CRT RUN IN CYCLE PROJECTOR WARM UP

MEMORYBANKS : ON

Select with or then <ENTER> <EXIT> to return.

SERVICE MODE

PROJECTOR SET-UP MEMORY MANAGEMENT

COMMON SETTINGS 12C DIAGNOSTICS

Select with or then <ENTER> <EXIT> to return.

7-9