Runco DTV-947 Location and Function of Controls, RS 232 Input Port, RS 232 Output Port, IR Sensor

LOCATION AND FUNCTION OF CONTROLS

RS232 IN	RS232 OUT	IR	COMM PORT REMOTE	R	G(s)	B	H	V	VIDEO S - VIDEO This device complies with part 15 of
									the FCC rules. Operation is subject to
									following two conditions (1), This
									device may not cause harmful inter-
									ferance, and (2) this device must
									accept any interferance received
									including interferance that may cause
									undesired operation.

1 2 3 4 5 6 7 8

1

2

3

4

5

6

RS 232 Input Port

Connection between the controller and projector. Connect the RS- 232 output from the controller to this port.

RS 232 Output Port

RS 232 Input Port allows a communication link for PC or MAC to the next projector in a series of projectors.

IR Sensor

Receiver for control signals transmitted from the RCU.

Communication Port -not used.

IR Remote

Connector for remote input for hard wired remote control

RGBHV or Component Input (5x BNC connector): Connect the RGB output from the VHD controller here.

Line inputs:	-signals RED-GREEN-BLUE
	-Horizontal and Vertical Sync
	-If using Composite Sync, connect it to ‘H’.

(R-Y)Y(B-Y)-S Input (component input): allows to connect e.g. a DTV Decoder having component outputs to the projector.

Line inputs -signals RED-LUMA, LUMA, BLUE-LUMA

7

8

VIDEO Input (Composite video, 1x BNC connector): Allows a video tape recorder, video camera, color receiv- er/monitor, etc. having video line output to be connected to the projector.

S-VIDEO Input: Separated Y/C (luma-chroma) signal inputs and outputs for higher quality playback of DVD signals (4-pinS-VIDEO connector loop-through).

2-1