Service Mode

Change Projector Address

Every projector requires an individual address between 0 and 255. This address can be software installed.

To change that address, push the control disc up or down to highlight ‘Change Pro- jector Address’ and press ENTER. The Change Projector Address menu will be displayed and the actual address will be filled in.

ENTER displays the 'Change Projector Address' menu. EXIT returns to the Service mode main menu.

The first digit is highlighted. Select the individual digits by pushing the control disc to the right or to the left. Reprogram with the digit keys on the RCU.

Press ENTER to confirm.

Press EXIT to return the projector set up menu.

Change baudrate

The communication speed between projector and computer has 8 possible speeds. The baud rate speed can be software set up. Highlight ‘Change Baudrate’ by push- ing the control disc up or down and press ENTER to display the Baud rate menu.

The following baud rates are available :

-9600

-4800

-2400

-1200

-600

-300

-150

-110

The actual baud rate will be highlighted. To change the baud rate, push the control disc up or down or to the left or to the right to select the desired baud rate and press ENTER to accept this baud rate.

ENTER to accept the selected baud rate.

EXIT to return without changing the baud rate.

PROJECTOR SET-UP

IDENTIFICATION

TOTAL RUN TIME

CHANGE PASSWORD

CHANGE LANGUAGE

CHANGE PROJECTOR ADDRESS

PROJECTOR ADDRESS

Enter new projector

 

address :

 

0 0 0

 

Use

and

to select,

and reprogram

with numeric keys.

Highest address is 255

<ENTER> to confirm

<EXIT> to return.

PROJECTOR SET-UP

IDENTIFICATION

TOTAL RUN TIME

CHANGE PASSWORD

CHANGE LANGUAGE

BAUDRATE

 

Select new

 

baudrate :

 

9600

4800

2400

1200

600

300

150

110

Select with arrow keys:

<ENTER> to confirm

<EXIT> to return.

Power up mode

When pressing the power switch, the projector can start up in ‘operating mode’ or in ‘stand-by mode’.

Operating mode : the projector start up and displays image.

Stand-by mode : the projector start up in stand-by and waits until the stand-by but- ton or a digit key is pressed.

To change the Power up mode, select Power Up mode by pushing the control disc up or down and press ENTER to toggle between ‘Operating’ and ‘Standby’.

ENTER to toggle between operating and standby.

EXIT to return to the Service menu.

PROJECTOR SET-UP

IDENTIFICATION

TOTAL RUN TIME

CHANGE PASSWORD

CHANGE LANGUAGE

CHANGE PROJECTOR ADDRESS CHANGE BAUDRATE

POWER UP MODE: operating

Select with or then <ENTER> <EXIT> to return.

7-4

Page 37
Image 37
Runco DTV-947 manual Change Projector Address, Change baudrate, Power up mode