Runco DTV-947 manual MESSAGES, WARNINGS, and Failures

MESSAGES, WARNINGS, AND FAILURES

INPUT 01

Fh= 15.6 kHz

Fv= 050 Hz

SOURCE 01

enter password

X X X X

text on

text off

PROJECTOR ADDRESS:

003

PROJECTOR ADDRESS:

003

WARNING:

invalid key entry

When selecting a new source, information about this source will be displayed on the screen. Source number, horizontal and vertical frequencies of the dis- played source.

Announcement of the selected source.

Message to enter your password. Password contains 4 digits.

These messages will be dis- played on the screen when push- ing the TEXT key.

Text ON : the ‘bar scale indica- tion’ will be enabled during the change of an analog control in the ‘operational mode’ + all warnings and failures will be dis- played.

Text OFF : the ‘bar scale indica- tion’ will be disabled during the change of an analog control in the ‘operational mode’ + all warnings and failures will not be displayed.

Indication of the projector address when activating the ‘ADDRESS’ button on the RCU with a pencil or other small object.

The input is a valid input but the source is not connected to the input terminals or the input source is switched off.

When a wrong key is pressed on the RCU.

WARNING:

invalid key entry

WARNING:

end of ad- just range

WARNING: input no longer available

WARNING: invalid

frequency input

table is deleted

FAILURE

I2C error addr.: 7FH3

FAILURE short circuit on 12C bus

Message when the entered pass- word is wrong.

End of adjustment range.

Message will be displayed when the input source is no longer available. The following mes- sage then appears: ‘check input signal or select new source’.

The entered frequency or applied frequency of the source is out of the projector’s range

Message to inform that selected table is deleted. This message will be followed by ‘confirm message’, on which the user has to answer.

Hardware failure. Call a quali- fied service technician for repair.

Hardware failure. Call a quali- fied service technician for repair.

8-1