Runco DTV-947 manual Connecting an S-Video or Video source to the S-Video input, Input selection

Connections

Connecting an S-Video or Video source to the S-Video input

RS232 IN	RS232 OUT	IR	COMM PORT REMOTE	R	G(s)	B	H	V	VIDEO S - VIDEO This device complies with part 15 of
									the FCC rules. Operation is subject to
									following two conditions (1), This
									device may not cause harmful inter-
									ferance, and (2) this device must
									accept any interferance received
									including interferance that may cause
									undesired operation.

Separate Y-luma/C-Chroma signals for higher quality playback of Super

VHS signals.

Note: S-video should normally be connected to the controller.

Luma / Chroma

VCR S-VIDEO or DVD

4 pin connector configurations:

For S-video:	For video:
Pin 1: earth(ground) luminace	Pin 1: earth(ground) video
Pin 2: earth(ground) chrominance	Pin 2: not connected
Pin 3: luminance signal(Y)	Pin 3: video signal
1Vpp+3dB _	Pin 4: not connected
Pin 4: chrominance signal(C)
_
300mVpp+3dB

Input selection

a. with the RCU: Select “S-Video” in the source selection menu.

b. with the local keypad

-press ADJUST key, the General access menu will be dis played on the screen.

-use the control disk to highlight 2.

-press ENTER to select the highlighted source.

	GENERAL ACCESS
		SHARPNESS
		TINT
5	6	COLOR
3	4	BRIGHTNESS
1	2	CONTRAST
Enter ADJUST
	Select with	,
		or
	then <ENTER>.

<EXIT> to return

FROM LOCAL KEYPAD

3-3