Runco DTV-947 manual YYB-Y3S or R-YY3sB-Y input selection, RS232 OUT Comm Port Remote

Connections

(R-Y)Y(B-Y)3S or (R-Y)Y3s(B-Y) input selection

a. With the RCU: Select “Component” in the Source Selection Menu

b. With the local keypad :

(to gain access to the local keypad, see ‘Local keypad’ in chapter ‘Location and function of controls’.)

-Press ADJUST key, the General access menu is displayed on the screen.

-Use the control disk to highlight 6.

-Press ENTER to select the highlighted source.

	GENERAL ACCESS
		SHARPNESS
		TINT
5	6	COLOR
3	4	BRIGHTNESS
1	2	CONTRAST

Enter ADJUST

Select with ,

or

then <ENTER>.

<EXIT> to return

FROM LOCAL KEYPAD

SOURCE SELECTION

SELECT AN INPUT

FROM BELOW:

RGB

S-VIDEO

VIDEO

COMPONENT VIDEO

Select with

or then <ENTER>

<EXIT> to return

FROM RCU

Connecting a computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS232 input of the projector.

RS232 IN	RS232 OUT	IR	COMM PORT REMOTE	R	G(s)	B	H	V	VIDEO S - VIDEO This device complies with part 15 of
									the FCC rules. Operation is subject to
									following two conditions (1), This
									device may not cause harmful inter-
									ferance, and (2) this device must
									accept any interferance received
									including interferance that may cause
									undesired operation.

12v Fuse

Mask Screen

The projector has a RS232 port that allows it to communicate with the VHD Controller.

The VHD Controller will communicate with the projector via its RS232 output. This communiction includes on/off commands and source switching commands (see the VHD Controller of this manual). This allows much easier integration into your home theater system by only having to control a single piece of gear.

3-6