Runco DTV-947 manual Getting Started, Quick SET-UP Guide

QUICK SET-UP GUIDE

Getting Started

To get started using your DTV-947 system, follow these simple steps:

1.Ensure all sources that you are using are properly connected to the controller. This is something your Runco dealer has probably already done for you; if not, please refer to the ‘Connection Examples’ and the owners manuals of each appro- priate source as necessary.

2.Turn on all sources. If a A/V receiver or a Runco OVSS-8 is being used to switch the video, ensure that is also turned on.

3.Turn on the controller. Make sure the Main Power switch (pg. 11-8) is ON, then press the power button on the front of the controller (or the power button on the remote). Ensure the red LED lights up on the front of the controller.

4.Turn on the projector.

5.With the left or right buttons on the front panel or remote, select the desired source. You may also do this by going through the menu (see pg. 11-14).

6.Select the desired aspect ratio by using the up and down buttons on the front panel or the remote. You may also do this by going through the menu (see pg.11-14). For an explanation of Aspect ratios, please refer to pg. 11-18.

11-12