Pioneer DEH-P7900BT Resetting the microprocessor, Use and care of the remote control

Before You Start

Section

01

2Replace the front panel by clipping it into place.

Resetting the microprocessor

The microprocessor must be reset under the following conditions:

!Prior to using this unit for the first time after installation

!If the unit fails to operate properly

!When strange or incorrect messages ap- pear on the display

Reverse mode

If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds. Pressing BAND when power to this unit is turned off while the ignition switch is set to ACC or ON cancels the reverse mode. Press BAND again to start the reverse mode.

Feature demo mode

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON. Pressing DISPLAY during feature demo operation can- cels the feature demo mode. Press DISPLAY again to start the feature demo mode. Remem- ber that if the feature demo continues operat- ing when the car engine is turned off, it may drain battery power.

English

%Press RESET with a pen tip or other pointed instrument.

Use and care of the remote control

Installing the battery

Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus (–) poles pointing in the proper di- rection.

!When using for the first time, pull out the film protruding from the tray.

RESET button

About the demo mode

This unit features two demonstration modes. One is the reverse mode, the other is the fea- ture demo mode.

Important

The red lead (ACC) of this unit should be con- nected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained.

WARNING

Keep the battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.

CAUTION

! Use only one CR2025 (3 V) lithium battery.

En 9