Pioneer DVR-650H-S manual Repairing disc, Repairing the HDD, Could not repair the disc

Additional information	15
Message	Explanation/Action
• Repairing disc.	During recording, the power was cut. This display
• Repairing the HDD.	appears when the power is restored.
• Could not repair the disc.	The recorder was unable to repair the disc after a
	power cut. The contents of the recording will be
	lost.

•Overheating has stopped operation. Press DISPLAY to clear message.

The internal temperature of the recorder has exceeded the operating limit. If this message reappears, please ask your nearest Pioneer- authorized service center or your dealer to carry out repairs.

•HDD optimization is recommended. This can be done using Disc Setup.

The HDD should be optimized (basically, HDD housekeeping) to maintain playback and recording performance.

•Please perform HDD optimization. The HDD is in more urgent need of optimization in

This can be done using Disc Setup.	order to maintain performance.
• The HDD has not been sufficiently	If this message appears repeatedly after
optimized. Please optimize again.	optimizing the HDD it is likely that there is not
	enough free space on the HDD for optimization to
	complete properly. Please erase some titles from
	the HDD and optimize again.

•An error occurred. Please consult the service center. Note that contents on the HDD may be erased when servicing this unit.

This message is displayed when information from the HDD cannot be read. The HDD may be damaged or broken. Please ask your nearest Pioneer-authorized service center or your dealer to carry out repairs.

•The Hard Disk Drive info is incorrect. Use the Disc Setup menu to reinitialize.

As the HDD info cannot be properly read, no new recordings can be made. Reinitializing the HDD (page 101) may result in your being able to make recording again. Note that reinitializing the HDD will erase all recorded contents, including protected files.

•This signal’s TV system is different from the recorder’s setting.

The TV system (PAL, NTSC, etc.) of the current channel is different from the TV system settings of this recorder.

•Recording failed due to a TV system The timer recording failed because the TV system

mismatch. Press DISPLAY to clear	of the channel set for recording was different from
message.	the setting of the recorder.

•Playback has stopped because the TV During recording or timer recording standby, the system is different than the recording. TV System (PAL, NTSC, etc.) of the playback video

changed, causing playback to stop automatically.

125

En