Pioneer DVR-520H, DVR-720H manual Video Plus+ programming with the power off, LUS Code, Next

Recording 06

•Press REC MODE to select FINE, SP, LP, EP or AUTO (See Recording time and picture quality on page 46). If Manual Recording is on, then you can also select the MN setting.

• Use the (cursor left/right) buttons to select the Once, Daily or Weekly recording option.

•Press HDD to record to the hard disk drive, or DVD to record to a DVD.

• Use the	and	buttons to switch VPS/PDC On
or Off.

2After making the settings, press ENTER. The program details are shown at the bottom of the screen for a few seconds then the screen is automatically exited.

•If you haven’t set up the guide channels (or at least the guide channel for the PlusCode programming number that you entered), the recorder will prompt you to enter the channel number that the TV program is showing on.

Tip

•You can check the timer program settings by pressing TIMER REC to display the timer recording screen.

VIDEO Plus+ programming with the power off

You can enter a PlusCode programming number when the recorder is in standby. Note that the recording is always made to the HDD. If you want to record to a DVD disc, you’ll need to switch on the power and use the full VIDEO Plus+ program screen.

VIDEO Plus+

CLEAR

ENTER

Important

•You can’t use this feature until you have set up the guide channels. See Set VIDEO Plus+ CH on page 101.

•You can’t change the recording mode.

•You can’t program daily or weekly timer recordings.

1 Press ’VIDEO Plus+’.

The front panel display shows the current recording mode and prompts you to enter the PlusCode programming number.

P LUS CODE

2Use the number buttons to enter the PlusCode programming number.

		2 9 32 4
• To clear the last digit entered, press CLEAR.
• Use the PREV	NEXT	button to switch VPS/

PDC on/off. With VPS/PDC on, the front panel VPS/ PDC indicator lights. (Note that a maximum of 8 timer recordings can be set with VPS/PDC on.)

3 Press ENTER.

The display shows the timer settings:

Date Start time End time HDD and Recording channel.

•If CODE ERROR appears in the display, check that the PlusCode programming number is correct and that the guide channel is set (see Set VIDEO Plus+ CH on page 101), then set the timer recording again.

•If CAN’T SET appears in the display, it means that although you entered a valid PlusCode programming number, the program has already finished.

PREV NEXT

53

En