Pioneer FH-P800BT Connecting and disconnecting a cellular phone, BT Hands Free, Pair from Phone

	Section
Operating this unit	02

2Use MULTI-CONTROL to select

CONNECTION.

The connection menu is displayed.

Turn to change the menu option. Press to se- lect.

3Turn MULTI-CONTROL to select the function.

PAIRED PHONE (paired phone)—

BT HANDS FREE (new phone)—SET PHONE (phone registration)—DISCONNECT PHONE (disconnect phone)—DELETE PHONE (delete phone)

If the phone is not connected and not paired

The following function can be operated.

!BT HANDS FREE (new phone)

If the phone is not connected but paired

The following functions can be operated.

!PAIRED PHONE (pair phone manually)

!BT HANDS FREE (new phone)

!DELETE PHONE (delete phone)

If the phone is connected but not paired

The following functions can be operated.

!SET PHONE (phone registration)

!DISCONNECT PHONE (disconnect phone)

!DELETE PHONE (delete phone)

If the phone is connected and paired

The following functions can be operated.

!DISCONNECT PHONE (disconnect phone)

!DELETE PHONE (delete phone)

Connecting and disconnecting a cellular phone

Using a cellular phone to initiate a connection

1 Display the connection menu.

Refer to Introduction to connection and pairing on the previous page.

2Use MULTI-CONTROL to select

BT HANDS FREE.

3Use MULTI-CONTROL to select a group. Push MULTI-CONTROL up or down to select a group.

NOKIA (Nokia)—STANDARD (standard)

#Normally select STANDARD. If the device of Nokia is not paired to this unit, select NOKIA.

#Push MULTI-CONTROL left or right to display a group name or an ID.

4Press MULTI-CONTROL to switch to

PAIR FROM PHONE.

Push MULTI-CONTROL up or down to switch PAIR FROM PHONE and SEARCH DEVICE.

5Select PAIR FROM PHONE and then press MULTI-CONTROL to ready for pairing. READY will be displayed.

6Use your cellular phone to establish connection.

PIN code is set to 0000 as the default. You can change this code in the initial setting. Refer to Entering PIN code for Bluetooth wireless con- nection on page 51.

While connecting, CONNECTING is displayed. If the connection is established, COMPLETED is displayed.

After connected, this unit automatically changes to PH.BOOK DL (phone book down-

load confirmation) display.

# If the connection fails, ERROR is displayed. In

this case, check the cellular phone and try again.

# If three cellular phones have already been paired, the pairing assignment selection display will appear. Select one assignment to pair the new phone. The newly paired phone overwrites the previously paired phone. The assignment se- lection operation is the same as Step 3 to 4 of Pairing a connected cellular phone on page 33 ex- cept for the operation below.

!Switching the BD address and device name

7Use MULTI-CONTROL to decide to download the phone book from your cellu- lar phone or not.

Push MULTI-CONTROL left or right to select NO (No) or YES (Yes).

Press MULTI-CONTROL to decide.

Operating this unit

En 31