13 Useful Features
98
En
Presetting manufacture codes
1Slide the Mode switch to match the device to
which you want to preset the remote control
signal.
2Press EDIT/LEARN and 1 at the same time.
•The LED flashes.
3Press 0 – 9 to enter the manufacture code. See
page 99.
•Preset mode is finished once the LED no longer
lights up.
•To exit the Edit mode halfway, press EDIT/LEARN
again.
•If the Mode switch selection is changed when in the
Edit mode, the Edit mode is cancelled.
•If no operation is performed for more than one
minute, the Edit mode is cancelled.
•When you enter a code not listed, the LED flashes
quickly.
•If the table on page 99 does not include your desired
manufacturer or the remote control does not work,
you can make the memory learn its signal by the
Learn mode.
•The initial mode is “000” (PIONEER).
PDP-ELITE-Eng (97-105) 9/9/03, 11:4798