Pioneer RS-P90 Adjusting the filter, Press the 2/3 buttons to set up the cut-off frequency of the

Audio Adjustment <Network>

Adjusting the filter

First, determine the approximate band to be used, taking into consideration the reproduced frequency band and the characteristics of the connected speaker.

1.Open the cover of the remote control in the network menu (refer to page 5).

This switches to network menu setting screen.

2.Press the FUNCTION button 1.

The display switches to filter adjustment screen, allowing filter adjustments.

3.Press the FUNCTION button 6 for two seconds and switch between left/right independent mode (L/R) and left/right combine mode (COM).

4.Press FUNCTION button 6 and select left (Left) or right (Right) channel (only for L/R mode).

Each press the FUNCTION button 6 switches left and right channel.

•Even when using the left/right combine mode you can switch to display left and right channels, but adjustments are those performed in the left/right combine mode.

5.Press FUNCTION buttons 1 or 2 and select the filter to be adjusted.

Press the button to switch the band to be adjusted and high pass filter/low pass filter.

6.Press the 2/3 buttons to set up the cut-off frequency of the

selected filter (crossover frequency).

Holding down these buttons continues their operations.

7.Set up the cut-off frequencies of each filter for all the bands.

Repeat steps 5 and 6 to adjust each filter so that the band used and crossover frequency are appropriately located.

38

38

ENG/MASTER 96