Other connections | 08 |
Connecting external antennas | About control out connections |
For an external AM antenna, use 5 to 6 meters of vinyl- insulated wire and set up either indoors or outdoors. Leave the loop antenna connected.
For an external FM antenna, use a PAL connector to hook up an external FM antenna.
external FM antenna
Receiver subwoofer
Side panel
ANTENNA
AM LOOP
FM
UNBAL 75 Ω
AM Loop antenna
external AM antenna
PAL connector
Indoor antenna
5 m to 6 m | Outdoor antenna |
Many Pioneer components support CONTROL connections, by which you can use the remote controls of any connected components by aiming them at the sensor of just one component.
When you use a remote control, the control signal is passed along the chain to the appropriate component.
If you choose to use this feature, you must make sure that you also have at least one set of HDMI or analog audio jacks connected to another component for grounding purposes.
•Using the supplied control cable on either side, connect the CONTROL IN jack on another Pioneer component to the CONTROL OUT jack on the receiver subwoofer.
This will allow you to control the other component by pointing its remote at the display unit supplied with this receiver subwoofer.
Connecting using HDMI
If you have an HDMI or DVI (with HDCP) equipped component, you can connect it to this receiver using a
commercially available HDMI cable.1
The HDMI connection transfers uncompressed digital video, as well as almost every kind of digital audio that the connected component is compatible with, including
Receiver subwoofer
HDMI
T | IN 3 | IN 2 | IN 1 |
HDMI
OUT | IN 3 | IN 2 | IN 1 |
SYSTEM
Rear panel
From HDMI output
Note
1 • An HDMI connection can only be made with
•This unit has been designed to be compliant with HDMI
•This unit supports SACD, Dolby Digital Plus, Dolby TrueHD and
35
En