Pioneer VRD1160-A operating instructions Connecting Up Easy connections, English, To power outlet

Connecting Up

Easy connections

A/V IN

TV

AV CONNECTOR 1 (RGB)-TV AV CONNECTOR 2

	OPTICAL	COAXIAL	L	CENTER
			L
					1	2
IN	OUT			AUDIO OUT			1	2	Y	PB	PR
				(5.1ch)
			R

			R	SUB
CONTROL	DIGITAL AUDIO	AUDIO	FRONT SURROUND	WOOFER	VIDEO	COMPONENT VIDEO OUT
	OUT	OUT		S-VIDEO
				OUT	OUT
		(2ch)

To power outlet

02

English

The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In this setup, stereo audio is played through your TV.

•This player is equipped with copy protection technology. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. (This player may also not be compatible with some combination TV/VCRs for the same reason; refer to the manufacturer for more information.)

1Connect the VIDEO OUT (1) and AUDIO OUT (2ch) jacks to a set of A/V inputs on your TV.

Use the supplied red/white stereo audio and yellow video cable. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound.

See the next page if you want to use an S-video, component or a D video connection.

•If you need another pair of stereo outputs (and don’t need to use the multichannel analog outputs), you can use the AUDIO OUT (5.1ch) FRONT L / R jacks (page 13).

2Connect the supplied AC power cord to the AC IN inlet, then plug into a power outlet.

•Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front

panel STANDBY/ON button, or the remote control, and wait of the -OFF-message to disappear from the player’s display.

•For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers.

11

En