Controlling the rest of your system
Programming signals from other remote controls
If the preset code for your component is not available, or the available preset codes do not operate correctly, you can program signals from the remote control of another component. This can also be used to program additional operations (buttons not covered in the presets) after assigning a preset code.
1While pressing the RECEIVER button, press and hold the 1 button.
The remote LCD display shows SETUP.
2Press the MULTI CONTROL button for the component you want to control.
The LCD on the remote displays the component you want to control.
•You can’t assign the RECEIVER button.
3 Use (cursor left/right) to select LEARN then press ENTER.
PRES KEY shows in the LCD display.
• To exit or cancel press RECEIVER.
4Point the two remote controls towards each other then press the button that will be doing the learning on this receiver’s remote control.
PRES KEY starts flashing to indicate the remote is ready to accept a signal.
•The remote controls should be
1 – 2 inches
5Press the corresponding button on the other remote control that is sending (teaching) the signal to this receiver’s remote control.
For example, if you want to learn the playback control
signal, press and hold for a couple of seconds. The LCD display will show OK if the operation has been learned.
If for some reasons the operation hasn’t been learned the LCD will display ERROR briefly and then display PRES KEY again. If this happens, keep pressing the (teaching) button as you vary the distance between the two remotes, until the LCD display shows OK.
09
Certain buttons represent operations that cannot be learned from other remote controls. The buttons available are shown below:
RECEIVER | INPUT | SOURCE | |
SELECT | |||
|
|
DVD/LD |
| TV/SAT | DVR/VCR | TV CONT |
|
| MULTI CONTROL |
| |
CD |
| TUNER | RECEIVER | |
INPUT ATT | FLDIMMER | SR | ||
| +10 |
| DISC | |
|
|
|
| ENTER |
D.ACCESS |
|
|
| CLASS |
TOP MENU |
|
|
| MENU |
|
| TUNE |
|
|
DTV MENU | ST | ST |
| |
T.EDIT |
| ENTER | BAND | |
|
|
| ||
SYSTEM TUNE |
|
| ||
GUIDE SETUP |
| RETURN | ||
|
| TV CONTROL |
| |
TVVOL |
| INPUT | TV CH | VOL |
|
| SELECT |
|
|
DTVON/OFF |
| REC | DTVINFO | MUTE |
TUNER |
|
| RECSTOP |
|
DISPLAY |
|
|
| |
MPX |
| CHRETURN | HDD | DVD |
AUDIO |
| SUBTITLE | ||
|
|
| CH | CH |
|
| RECEIVER CONTROL |
| |
THX |
| STANDARD | ADV.SURR | STEREO |
|
| ACOUSTIC | SIGNAL | MIDNIGHT/ |
AUTO SURR | EQ | SELECT | LOUDNESS | |
SHIFT |
| EFFECT | SLEEP | DIALOG E |
| /CHSEL |
RECEIVER
6To program additional signals for the current component repeat steps 4 and 5.
To program signals for another component, exit and repeat steps 1 through 5.
7Press the RECEIVER button to exit and store the operation(s).
Note
•Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or farther apart.
•If the remote LCD shows ERROR, it may also mean the memory is full. See Erasing one of the remote control button settings below to erase a programmed button you’re not using to free up more memory.
• TV CONTROL buttons (TV ,TV VOL
51
En