Pioneer VSX-29TX manual Digital Input Select

Initial Set Up

DIGITAL INPUT SELECT

In order to be able to use your digital equipment properly you need to assign digital inputs for each of the digital components you connected. Match the DIGITAL IN buttons 1-4 with the digital jacks 1-4 in accordance with what component is hooked up to each digital jack. Check the digital terminal numbers on the back of the receiver to make certain what component is in which jack (if necessary, see p.10 for more on digital connections). The last button, the AC-3 RF button, is specifically for a DVD/LD or LD player with an AC-3 RF output. If you connected one of these components match this button to the component. If continuing from BASS PEAK LEVEL MANAGER go to step 1. If starting fresh, complete steps 1-3 in “Setting Up for Surround Sound“ (p.23) first.

System Setup	EXIT
SPEAKER	BASS PEAK LEVEL
SETTING	MANAGER
CHANNEL DELAY	DYNAMIC RANGE
	CONTROL
CHANNEL LEVEL	DIGITAL INPUT
	SELECT
CROSSOVER	MULTI ROOM
NETWORK

11 Press the DIGITAL INPUT SELECT button.

2 Press the DIGITAL INPUT SELECT button you want to assign to select it. Each further press scrolls through the possible components (functions) you can choose from. Select the component you hooked up to that digital input with that number.

This procedure assigns a digital function to the DIGITAL IN. Once one function (for example DVD/LD) has been assigned its name disappears from the possibilities on the remaining buttons because one function cannot be assigned twice.

If a digital jack has nothing connected to it set the corresponding button to OFF.

		2,3
Digital Input Select
DIGITAL IN 1	DIGITAL IN 2	DIGITAL IN 3
DVD/LD	CD	MD
DIGITAL IN 4	AC-3 RF		4
TV/SAT	DVD/LD

SETUP

OK

3 Repeat step 2 until all the digital in buttons correspond to the components you connected.

4 If you hooked up a DVD/LD or LD player to the AC-3 RF channel choose the proper component with the same method described above.

5 Press SETUP OK to return the SYSTEM SETUP mode.

Hold the remote control pointed towards the receiver until you see the “RECEIVED” display on the receiver.

Ç

5

If "ERROR" flashes in the display, perform the setup operations from the first step again.

SIGNAL		VOLUME
SELECT	A
ANALOG SP

dB

The remaining possible choices for the digital inputs are shown in the diagram on the right.

Digital Input Select

DIGITAL IN 1	DIGITAL IN 2	DIGITAL IN 3
DVD/LD	CD	MD
DIGITAL IN 4	AC-3 RF
TV/SAT	DVD/LD
		SETUP
		OK

These settings will be displayed on your TV. (The settings pictured here are the default settings.)

Digital In-Select
Digital-1	[DVD/LD]
Digital-2	[	CD	]
Digital-3	[	MD	]
Digital-4	[TV/SAT ]
RF L	[DVD/LD]

memo • For the DIGITAL IN 1-4 buttons you can choose between DVD/LD, CD, TV/SAT, MD/TAPE 1, VCR 1 and VCR 2 functions.

•For the AC-3 RF button you can choose between DVD/LD, TV/SAT, VCR 1 and VCR 2 functions.

Remember, if you have a DVD/LD player or LD player you should hook it up to the analog and digital jacks in addition to the AC-3 RF connection described here.

32