Pioneer VSX-29TX manual Locking the Settings, Lock symbol

Remote Control of Other Components

5 6

5 Point the two remote controls toward each other. Press the button on the other remote control corresponding to the operation you want to program.

RECEIVER

DVD/LD

DVD:OK

EXIT

1 2 3

REMOTE

SETUP

MD/TAPE1

LEARNING flashes in the display on the remote control. After the process is complete and the command has been learned, OK will appear at the top of the remote control LCD display. If NG (no good)

TV/SAT	SEARCH
	MODE
VCR1	TOP
	MENU
VCR2	MENU SET UP

4 5 6

7 8 9

10 0 C

CD

TUNER

TV

CONTROL

appears, it means that for some reason the command was not learned.

Repeat steps 4 and 5 to teach the remote control of the VSX-29TX all the commands from remote control.

RECEIVER

DVD/LD

TV/SAT

VCR1

VCR2

ÇEXIT

LearningEXIT

SELECT FUNCTION

REMOTE

SETUP

MD/TAPE1

CD

TUNER

TV

CONTROL

5 ~ 12 inches

6 Press EXIT to return to the LEARNING/SELECT FUNCTION screen.

Start again from step 3 to program all your components in this manner.

When you're done press EXIT repeatedly to return to the REMOTE SETUP menu.

memo Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved

closer together or farther apart.

Locking the Settings

This feature allows you to lock the SYSTEM SETUP and REMOTE SETUP settings so that they cannot be changed without unlocking them first. When they are locked you cannot enter the setting screen in these modes. The locking and unlocking procedures are done by the same procedure.

1	Lock symbol
			on off
			BACK LIGHT
	Remote Setup	EXIT	TV
RECEIVER			REMOTE CONTROL
			SETUP

	LCD	MULTI OPERATION
DVD/LD	COMMANDER		MD/TAPE1	FUNCTION

CH +

TV/SAT	PRESET RECALL	DIRECT FUNCTION	CD
			CH –
	LEARNING		VOL +
VCR1			TUNER

VOL –

VCR2	CONTROL	FUNCTION
	TV

				MASTER VOLUME
	MULTI	SYSTEM		+
STANDBY/ON	OPERATION	OFF	MUTING

ENTER

–

1 In the SYSTEM SETUP or REMOTE SET UP screens hold down the %´Þ buttons at the same time. A lock symbol with a box around it will appear in the top bar of the LCD screen.

2 Press the lock symbol while holding down the above two keys. The setting will either lock or unlock depending on the state it was previously in.

From that time, if the screen is locked the lock symbol will appear when that screen is accessed.

2

RECEIVER	Remote Setup		EXIT	REMOTE
				SETUP
	LCD	MULTI OPERATION
DVD/LD	COMMANDER			MD/TAPE1
TV/SAT	PRESET RECALL DIRECT FUNCTION			CD
VCR1	LEARNING			TUNER
VCR2				TV
				CONTROL
				MASTER VOLUME
		MULTI	SYSTEM	+
	STANDBY/ON	OPERATION	OFF MUTING

ENTER

–

on off

BACK LIGHT

TV

CONTROL

FUNCTION

CH +

CH –

VOL +

VOL –

FUNCTION

memo The only exception to LOCKING THE SETTINGS is the LCD COMMANDER settings in the REMOTE SETUP screen. They can

still be accessed even when the REMOTE SETUP screen is locked.

50