Pioneer VSX-29TX manual Channel Delay, Menu

Initial Set Up

CHANNEL DELAY

Adding a slight delay to some speakers is necessary to achieve a surround sound effect. You need to figure out the distance from your listening position to your speakers to add the proper delay. The following steps show you how to set the delay time for each channel by specifying the distances from your listening position to each speaker. Once you specify the speaker distances, the receiver calculates the correct delay times automatically. If continuing from SPEAKER SETTING go to step 1. If starting fresh, complete steps 1-3 in “Setting Up for Surround Sound“ (p.23) first.

	System Setup					EXIT			1	Press CHANNEL DELAY.
	SPEAKER			BASS PEAK LEVEL
		SETTING			MANAGER					The CHANNEL DELAY speaker settings will appear on your remote
1				DYNAMIC RANGE
	CHANNEL DELAY									control screen.
					CONTROL
	CHANNEL LEVEL			DIGITAL INPUT
							2
					SELECT
										Select each speaker by pressing its button and use the
	CROSSOVER			MULTI ROOM
	NETWORK									+/– (or %/Þ) buttons to add or subtract the distance in
										feet that the speaker is from your normal
										listening position.
	Channel Delay									Adjust the speaker distance in 1 foot increments from 1 to 30 feet (1
										foot equals approximately 0.3 meters).
										The default setting is 10 ft.
	10ft		10ft	10ft	10ft
2		10ft		10ft			3			Press SETUP OK to return to the SYSTEM SETUP
						SETUP		3		MENU.
										Hold the remote control pointed towards the receiver until you see
						OK
		Ç								the “RECEIVED” display on the receiver.
										If "ERROR" flashes in the display, perform the setup operations from
	Channel Delay									the first step again.

10ft 10ft 10ft 10ft

10ft 10ft

SIGNAL		VOLUME
SELECT	A
ANALOG SP

dB

These settings will be displayed on your TV.

SETUP

OK

DVD/LD

TV/SAT

VCR1

VCR2

Channel Delay
Front			[10ft]
	L
Center			[10ft]
Front			[10ft]
	R
Surround			[10ft]
		R
Surround			[10ft]
		L
Subwoofer			[10ft]

Next, proceed to CHANNEL LEVEL below.

If you want to change a setting before proceeding

Simply select the speaker you want to change.

memo You can use the %´Þ buttons at the bottom of the remote control instead of the +/– buttons

STANDBY/ON

ENTER

%´Þ buttons

26