Pioneer VSX-819H-S manual Connecting to the front panel video terminal, Connecting antennas

03Connecting up

Connecting to the front panel video terminal

Front video connections are accessed via the front panel using the INPUT SELECTOR or VIDEO button on the remote control. There are

standard audio/video jacks. Hook them up the same way you made the rear panel connections.

•Push down on the PUSH OPEN tab to access the front video connections.

iPod		VIDEO INPUT
USB	VIDEO	L AUDIO R

This receiver

SPEAKERS	MULTI-ZONE			MASTER
	CONTROL	ON/OFF		VOLUME
	iPod		VIDEO INPUT
	USB	VIDEO	L AUDIO	R
				MCACC
				SETUP MIC

Video camera

(etc.)

VIDEO L R

AUDIO/VIDEO OUTPUT

Connecting antennas

Connect the AM loop antenna and the FM wire antenna as shown below. To improve reception and sound quality, connect external antennas (see Using external antennas on page 21).

fig. a fig. b

2

ANTENNA

4

AM	3
LOOP

1

1Push open the tabs, then insert one wire fully into each terminal, then release the tabs to secure the AM antenna wires.

2Fix the AM loop antenna to the attached stand.

To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. a) then clip the loop onto the stand (fig. b).

3Place the AM antenna on a flat surface and in a direction giving the best reception.

4Connect the FM wire antenna in the same way as the AM loop antenna.

For best results, extend the FM antenna fully and fix to a wall or door frame. Don’t drape loosely or leave coiled up.

20

En